Efi Mac Mini
Efi Boot Mac Mini
Efi For Mac Mini Usb
Efi Update Mac Mini 2010
Efi Update Mac Mini

Our software library provides a free download of Mac mini EFI Firmware Update 4.0.1. The actual developer of this free Mac application is Apple Inc. Our built-in antivirus scanned this Mac download and rated it as virus free. The program lies within System Tools, more precisely Device Assistants. MacOS provides multiple methods to protect the data on a Mac: a user account password, encryption via FileVault, and optional low-level security measure that prevents starting up from storage devices other than the selected startup disk. That's known as the firmware password or EFI (Extensible Firmware Interface) lock, which will also block the user's ability. ICloud, MDM Removal, Firmware Unlock. Remove the EFI Password Lock. (iCloud, 4 pin, 6 pin lock). Note: Do not use your original serial number if your Mac has MDM or DEP profile. EFI Firmware Chip Card for Apple MacBook, MacBook Air, MacBook Pro, Mac mini. The EFI Card fixes EFI BIOS chip or firmware corruptions and boot loops that may have caused by Clover or similar EFI bootloaders. It also removes and unlocks the Mac (2010 – 2017) EFI BIOS passwords instantly. This is just a special EFI BIOS chip which uses a special connector on the logic board so it doesn’t require soldering.

The Mission

There has been much controversy on removing the firmware lock on a MBP, MBA, or similar Mac’s. The MBA is a bit more complicated without a specialty tool to interface with a header on the board. We use to have to remove the board, scratch back traces, and solder directly to them which can be seen in EX-1.1. This is just short of replacing the entire chip, which is what we are all trying to avoid right? I also have a project I have been forking on called the iFLRT (Firmware Lock Removal Tool) that can be found HERE. Donate what you can to keep my development process alive, every little red cent helps.

First you need to understand what the firmware lock is and how removing it will affect you. Then maybe you will be able to decide if this procedure is for you. In most cases a MBP has been purchased from a third party who may have stolen it or simply forgotten to remove their iCloud account. In this case the symptoms would be a four digit pin lock when the OS loads. When you try to do a re-install you are met with a lock screen shown in EX-1. This is the result of the Mac being most definitely locked from the cloud. There are two options from this point which are explained below.

EX-1

EX-1.1

NOTE: If you have a 2010 model MBP or earlier all you have to do is change the amount of RAM in your MBP and clear the PRAM. This is all you have to do to get past OS lock. But you will still have a firmware lock as far as I know as in many cases this has happened. There have been occasions where the firmware lock has also been removed but I cannot contest to any exact models. Remember to set the Mac up like new and register the Mac with a new iCloud account to avoid any future lock-downs.

Option A: You can assume that a firmware lock was never set and brute force the firmware lock with a HID device such as a Teensy. This operation can take quite a while because it has to go through 10,000 iterations of possible pass-phrases in the worst case scenario. This will ONLY work if it was set by the iCloud!

Option B: You can assume that a firmware lock was indeed implicated when the MBP was set up and that the brute force method will not work. This can save you time but requires you to have a SPI programmer at hand such as the Bus Pirate or in this case a Raspberry Pi.

In A Nutshell

I won’t waste time on the brute force method as I believe it isn't relevant in most cases. I will focus on the process of flashing the EFI chip that is usually easily accessible by removing the Macs’s back-plate, either by a small 15X2 header, 17X2 header, or the 8 pin SOIC chip itself. You can see an image of the SOIC8 chip in EX-2 and the header in EX-2.1. The process is simple but requires a bit of knowledge in micro controllers. I will use the easiest and cheapest route that I know. The process goes briefly like this:

EX-2

EX-2.1

Step 1 – Buy a SPI programmer such as the Raspberry Pi and a clip to interface with the chip. You can find the Pi on eBay, doesn't matter what model and you can find the Pomona SOIC8 clip there as well, usually with the female-to-female wires included. If you have a MBA then you can contact me about purchasing a clip for the header.

Step 2 - Read the chip three times and verify MD5 check-sum to ensure you have a good backup if things go wrong.

Step 3 – Make a copy of the dump and open it in a hex editor. I use Notepad ++.

Step 4 - Search for “$SVS” in the dump and you should find 2 instances. The first instance is what you will need to clear out making sure to keep the file length the same. It is safe to replace it with an empty value such as “ÿ”. The string including the $SVS should be replaced, you can copy and paste a portion of the string below if needed. each 'ÿ' is 2 bits and 8 bits make a byte So keep that in mind when you replace the string. The file size has to be exactly the same size as the chip or it will return an error.

This is an example of what to replace in a hex editor.

Step 4.1 – Get a clean dump that is not firmware locked from the community making sure you use the correct EMC and processor architecture. Make absolutely sure it is the same size as your original dump which is usually 2, 4, or 8 MB. If you go this route then you will need to replace the serial of the donated dump with your own serial in order to not register over their Mac. You can do this my simply searching for 'override-version' and on that same line there will be an 11 to 12 digit serial number that you will replace with your own. I also have a repository found HERE which you can use to search for your EMC number and I may have a clean dump.

Step 5 – Hook your programmer up to the chip, erase the chip, write the new dump and verify it.

Step 6 – Remove the clip and turn your Mac over to turn it on and test. You will immediately use the hot-keys to get to single user mode to test.

Step 7 – If you do not get to SU mode or the Mac does not boot right you will need to erase the chip and write the old dump back to it. You then can exhaust other options.

Step 7.1 – If you do get to SU mode turn the Mac back off and use the hot-keys to clear the PRAM. This will get rid of the 4 digit lock at OS load. Or you can simply re-install at this point. Remember to register the Mac to a new iCloud account to avoid future lock downs.

NOTE: Here are a few things worth mentioning..

Make sure your chip is supported in Flashrom which is the program you will be using to talk to the chip.
You need to make sure the clip makes a solid connection to avoid misreads.
You need to verify your chips datasheet to correctly identify the pin-out to the SPI programmer.
The wires connecting the clip to the SPI programmer need not be any longer than 8 cm.
The battery may need to be connected due to voltage drop in special cases (RARE).
The power cable should be removed from the Mac during the entire process, up until boot time testing.
Always make sure to back up your original dump and verify the write.
Optionally you can wire in resistors between the SPI programmer and the clip on the 3.3v pins.

That is the entire process in a nutshell. Now I will explain how you can do this in as much detail as possible. The first thing that you will need to do is pick up your entire inventory before you begin. After that lay everything out and do some testing. Make sure your chip is supported having the datasheet and any diagrams available. I also suggest after you get the clip connected to all the wires you check for continuity from the clips pins to the end of the F-F wires on each pin.

Down And Dirty

NOTE:Read this guide in its entirety before you attempt to do anything to your Mac; Read it twice if you have to. I would also like to take this time to tell you that I am not responsible for any damages to your personal property or your physical/mental welln

Efi For Mac Mini